Electrickit Advanced Remote Screen | Mounting Guide for Aga cookers
The remote screen will be supplied by your Blake & Bull engineer on the day of installation.
If you want to wall mount your screen there are preparations that you can make ahead of time.
Mounting your screen is not part of the Blake & Bull Electrickit Advanced installation.
To mount your screen you will need to buy a single gang pattress back box.
You can buy one that has to be chased in, or a simpler surface mounted/angle surface mounted.
Single gang pattress back box {dry lining example}
Single gang pattress back box with cable ‘push out’ 32mm deep & 35mm deep examples, widely available!
Or you may need an angle for your screen depending on access, this also may be useful when wanting the screen on the worktop, but fixed and secure. Single gang pattress angled surface mount for work top.
Our carpenter Ali {maker of our showroom cupboards} has also crafted these solid oak stands, coated in OSMO oil. They hold the screen in a slightly slanted position. The unit is loose in the stand, and the cable will travel across the worktop. Subject to availability.
Whichever back box you choose, please follow the guidelines here. Broken screens can be replaced at £198 ex VAT. Postage is free, delivery time is 1-2 weeks.
The screen comes with a 4mtr cable, and the green connector that your Blake & Bull engineer will connect to the system. The cable is grey and around 3-4mm in diameter.
The screen comes with a 4mtr cable, and the green connector that your Blake & Bull engineer will connect to the system. The cable is grey and around 3-4mm in diameter.
The green connector will be connected to the cooker during our visit leaving you 4mtrs of cable. You will need a soft cloth. A cross head and flat head screwdiver.
Turn the mains power off before you start work!
Gently use the flat head screwdriver in the notches to push down the clip and release the back from the screen. The back should release to reveal the circuit board.
Make sure to rest the screen on a soft clean dry cloth.You will be able to see the clip connectors inside.Release these, photograph this now, so you can remember!
Red - 9-36VGreen - 485_AWhite - 485_BBlack - GND
You can release the back plate fully from the screen. Position this on to your chosen back box Fix with the two provided screwsSecure well.
Re-fix the cables into their clips.
When you put the back box back on the screen, the flexible ribbon cable {bottom centre in this pic} must be at the base as the screen goes on.
The clips will align, and press in with a satisfying click! Pinch all sides. Do not press the glass.
When all is secure, you can restore power and the screen will re-set.
Enjoy!
Enjoy!
